Re-cover option
A retrofit re-cover avoids a tear-off when the structure checks out.
Metal Roofing
Metal Roof Replacement Cliffside Park, NJ
A Cliffside Park roofer can tear off an old metal roof, re-cover it with new metal or replace a shingle roof with metal, and help you decide between a tear-off, a re-cover or new panels in just the bad sections. Call (551) 378-0042 to reach a local roofer.
A metal roof needs replacing when the metal itself is failing, not just the screws. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Older roofs made from thin, lightly coated steel tend to reach that point first.
Not every metal roof replacement starts with a tear-off. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. A re-cover, or retrofit, installs new metal over the old panels on new sub-framing, which is common on shops and large buildings.
Many metal roof replacements are actually shingle roofs getting metal for the first time. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. It helps to know what is on the roof now, how old it is and whether it has ever been covered over.
If the problem goes deeper than it first looked, a Cliffside Park roofer may also recommend metal roof installation or metal roof repair.
Looking for Cliffside Park metal roof replacement? Call (551) 378-0042 to talk to a local roofer.
Call nowThe process
How metal roof replacement works
Here is how a metal replacement usually goes.
Assess the old roof
The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. This decides tear-off, re-cover or partial panel replacement.
Plan the new roof
The roofer and owner pick the panel profile, metal and color and decide how the old roof will be handled. Moving from purlins to standing seam often calls for a full deck.
Remove the old roof
The crew unscrews and lifts off the old metal, stacking it for recycling. Only as much roof is opened as can be covered the same workday.
Repair the framing
The structure is repaired so new fasteners bite into solid wood. New screws in rotten wood would fail within a few seasons.
Panel the roof
The roof is dried in, trimmed and paneled, with new boots and flashing at every penetration. Gutters may be reset to match the new eave line.
What is included
Parts of a metal reroof
Deck repair
The base under the roof is made sound for a straight, solid roof.
New trim
Matching flashing at every edge in the same finish as the panels.
Old roof removal
The worn roof is stripped down to the framing section by section.
New panels
The new metal system go on over new underlayment.
Related service
Metal Roof Panel Replacement Cliffside Park, NJ
When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. A new panel has to match the rib profile and lap direction so it seals against the panels around it. Concealed fastener panels take more time to replace because of the seams.
For a Cliffside Park building with one or two bad panels, panel replacement is often the sensible step. The new panels may look brighter until they weather. If many panels need swapping, a full replacement may make more sense.
Related service
Metal Roof Over Shingles Cliffside Park, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
What you give up is a look at the deck. Before going over shingles on a Cliffside Park home, the deck is checked from inside and any soft areas are found. Any sign of rot, or a second layer of shingles, tips the decision to tear-off.
Local help
Metal Roof Replacement Near Me
In Cliffside Park, many metal replacements are older galvanized roofs that have finally rusted through. Across Cliffside Park and nearby communities including Edgewater, Fairview, Ridgefield and Palisades Park, metal roofs that went decades without fastener work are the usual replacement jobs, and the right approach depends on what the old roof is hiding.
For metal roof replacement in Cliffside Park, NJ or nearby towns like Edgewater, Fairview, Ridgefield and Palisades Park, call (551) 378-0042 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Cliffside Park is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Roofers who know Cliffside Park
Local roofers see the same roofs and storm damage across Cliffside Park and nearby towns.
Know what happens next
Ask your questions before you agree to anything.
Metal Roof Replacement questions
Is it a good idea to put metal over shingles?
Where code permits, metal can go over a single layer of shingles. It works best when the deck is sound and the shingles lie flat. If the deck is questionable or there are two layers already, a tear-off is the better route.
Can a new metal roof go over the old metal roof?
A metal re-cover puts a new metal roof on top of the old one, attached through new framing to the structure. It is common on larger buildings where tearing off would disrupt use. The structure has to be checked first, since the old roof stays in place and adds weight.
How is a single metal roof panel replaced?
Single panel replacement is common on exposed fastener roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. New panels may look brighter than the old ones at first.
How do I know my metal roof is past repair?
The answer depends on how much of the metal is still sound. If panels are perforated, the coating is gone and the fasteners no longer hold, patches will not keep up. A roofer can tell you which sections can be saved after a look at the roof and the framing.
What happens to the old metal roofing?
Removed metal panels are generally recycled. The old panels and trim are separated and sent to a recycler. Confirm how disposal is handled when you schedule.
More questions? Call (551) 378-0042
Related services
Metal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, with high-temperature underlayment and proper flashing.
Learn moreMetal Roof Repair
Metal roof repairs that stop leaks at the screws, laps and flashing, without replacing panels that are still sound.
Learn moreRoof Replacement
A complete new roof from the deck up when repairs no longer make sense, with the old layers removed and the deck checked.
Learn moreStanding Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, for homes, additions and low slope roofs.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof replacement in Cliffside Park, NJ?
Call (551) 378-0042 for a local roofer in Cliffside Park and nearby towns.